Instruction Sheet

Schneider Electric USA

1601 Mercer Road

Lexington, KY 40511 USA

1-888-SquareD (1-888-778-2733)

www.us.SquareD.com

Circuit Breaker Load Centers 40269-469-02

Instruction Bulletin 03/2006

Electrical equipment should be installed, operated, serviced, and

maintained only by qualified personnel. No responsibility is assumed

by Schneider Electric for any consequences arising out of the use of

this material.

REMOVE COVER TWISTOUTS

NOTE: Remove only those twistouts which match installed circuit breakers by

twisting out with pliers at center of twistout.

IDENTIFY CIRCUITS

1. Identify branch circuits on directory label.

2. Handle at mid-position and red Visi-Trip

indicator show circuit breaker is

tripped.

3. To reset, move handle to OFF (O) position, then to ON (I) position.

NOTE: If load center is used as service equipment, apply “Service

Disconnect” label to cover near main circuit breaker handle. If load center is

not used as service equipment, apply “Main” label to cover near main circuit

breaker handle.

CAUTION

HAZARD OF EQUIPMENT DAMAGE

Remove main circuit breaker twistout only when main circuit breaker is installed. Close unused circuit breaker

openings with filler plates.

Failure to follow this instruction will result in equipment damage.

Table 1: Filler Plates

Type Usage

QOFP Closes 1-pole branch circuit breaker opening.

QOM1FP Closes 70–125 A main circuit breaker opening.

QOM2FP Closes 150–225 A main circuit breaker opening.

OFF

11003019

OFF

ON (I)

OFF (O) TRIPPED

40269-469-02.fm Page 4 Thursday, April 20, 2006 9:23 AM