User's Manual

January
2016 DocID0xxxxx Rev 0.17
This is preliminary information on a new product now in development or undergoing evaluation. Details are subject to change
without notice. www.st.com
7.2 IC certification
The SPBT3.0DP1 module has been tested and found compliant with the IC RSS-247 rules. These limits are
designed to provide reasonable protection against harmful interference in approved installations. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference may not occur in a particular installation.
This device complies with RSS-247 of the IC rules. Operation is subject to the following two conditions:
this device may not cause harmful interference, and this device must accept any interference received,
including interference that may cause undesired operation.
Modifications or changes to this equipment not expressly approved by STMicroelectronics may render
void the user's authority to operate this equipment.
The safe user distance, for RF Exposure, is ≥ 15mm (in compliance with RSS-102 Issue 5).
Modular approval
IC: 8976C-SPBT301
In accordance with IC RSS-247, the SPBT3.0DP1 is listed as a modular transmitter device.
This module is evaluated for stand-alone use only. Finished products incorporating multiple transmitters
must comply with colocation and RF exposure requirements in accordance with IC multi-transmitter
product procedures. Collocated transmitters operating in portable RF Exposure conditions (e.g. <20cm
from persons including but not limited to body worn and hand held devices) may require separate
approval.
7.2.1 Labeling instructions
When integrating the SPBT3.0DP1 into the final product, the OEM must ensure that the IC labeling
requirements are satisfied. A statement must be included on the exterior of the final product which
indicates that the product includes a certified module. The label should state the following (or similar
wording that conveys the same meaning):
Contains IC ID: 8976C-SPBT301
OR
This product contains IC ID: 8976C-SPBT301
The OEM must include the following statements on the exterior of the final product unless the product is
too small (e.g. less than 4 x 4 inches):
This device complies with RSS-247 of the IC Rules. Operation is subject to the following two conditions:
this device may not cause harmful interference, and this device must accept any interference received,
including any interference that may cause undesired operation.