Installation Instructions

12
Unroll the Seam Tape along the length of the seam, tape side
down, aligning the Seam Tape paper with the crayon marks.
Then with the release paper still in place, roll the Seam Tape
with a steel or hard rubber roller. This will set the Seam Tape
into place and keep air from being trapped under the tape. Fold
the top membrane onto the Seam Tape release paper (shown in
Figure 10).
Reaching under the top ply of membrane, pull the release
paper away from the Seam Tape at a 45º angle to the seam.
While removing the paper, draw your hand across the seam,
from the back to the leading edge. This will prevent wrinkles
and shmouths from forming in the seam. After the paper is
removed, roll the entire length of the seam with a steel or hard
rubber roller – rst, across the seam, and then the length of the
seam (shown in Figure 10a).
IMPORTANT! If the Seam Tape does not visibly extend beyond
the leading seam edge, the edge should be cleaned with Seam
Primer and sealed with Rubber Caulk.
NOTE: When splicing Seam Tape, overlap each piece a
minimum of three inches (3") and rmly roll with a steel or
hard rubber roller.