Installation Instructions

PERIMETER WALLS AND

INSIDE CORNERS

Install to the substrate the RoofKit 6" Reinforced Strip with

Fastening Screws and Plates every twelve inches (12"). Ensure

that the 6" Reinforced Strip is butted to the parapet wall.

Apply Multi-Purpose Bonding Adhesive to the 6" Reinforced

Strip, folded membrane, and the wall area. Starting at the base

or angle change between the corner and opposite end of each

wall, begin to roll the membrane up and along the wall. Roll the

excess membrane towards the corner. Take care to thoroughly

adhere the membrane into the angle change before rolling the

membrane up the walls. Roll the at surface of the 6" Reinforced

Strip with a steel or hard rubber roller. Broom or hand rub the

membrane to ensure 100% adhesion.

NOTE: Wall ashings should extend a minimum of twelve

inches (12") above the roof surface (shown in Figure 11).

When one side is adhered in (A), begin the other side, (B).

When both walls are ashed in, excess material should form a

pocket in the corner.

Clean and prime the inside and outside pocket “triangle” with

Seam Primer and apply Multi-Purpose Bonding Adhesive

to both sides of the pocket. (shown in Figure 11). Allow the

adhesive to dry to the nger touch as tacky, not stringy.

Note: It is important to adhere the wall ashing on each side of

the corner as tightly into the corner as possible.