Installation Instructions
15
OUTSIDE CORNER DETAIL
1. Prior to installing any ashings, using the scrub pad,
apply Seam Primer to all areas to be ashed. Cut the Tape
Flashing twelve inches (12") by twelve inches (12"), or
enough to cover the corner area. Round all corners of the
Tape Flashing. After the Primer has dried, fold the ashing
in half. Place the Tape Flashing against the vertical surface
so that three inches (3") overlaps on one side of the corner
and nine inches (9") overlaps the other side. Fold the
ashing around the corner and adhere to the vertical surface.
Ensure good contact at the angle change before extending
the ashing onto the at roof surface. The ashing should
extend out four inches (4") onto the roof surface, and eight
inches (8") up the vertical. See Figure 13A.
IMPORTANT: The Tape Flashing should
NOT BE STRETCHED EXCESSIVELY!