User Manual

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: [phone]
8. Reinstall rear O2 sensors – you will need to reroute the O2 lines, and in doing so
will not need to add extensions. (This is for catback exhaust with headers only).
9. Install ¼” thick stainless steel spacers between cross brace and bottom of the car
and tighten the (4) 15 mm bolts. See picture below.
10. Tighten and adjust as needed. Make adjustment so that X-pipe is above cross
brace by approx ½” to ¾” after tightening. See picture below.
11. For Convertibles only, using (6) 15mm bolts, bolt in the longer cross brace
supplied with kit CA11CONVKIT, with cutout toward the front of the car. See
picture below: