User's Manual

SET UP INSTRUCTIONS

Equipment Mat

LEVELING:

MOVING:

Locate and read the WARNING LABEL(85) on the SpaceMate

E300. Make sure that all

users read the WARNING LABEL(85).

CAUTION:

Place the SpaceMate E300 in the area where it will be used. It is recommended that the SpaceMate

E300 be placed on an equipment mat. The maximum operation dimensions of the SpaceMate E300 are

approximately 34 3/4" long x 23 1/8" wide x 54 3/8" tall. (These dimensions may vary up to one inch.) An

area 4 feet wide x 5.5 feet long is required for safe operation of the SpaceMate

E300. Make sure that

adequate space is available for access to and passage around the SpaceMate E300.

Grasp here to move

FUNCTION INSPECTION:

Visually inspect the SpaceMate E300 to verify that assembly is as shown in the above illustration. Check

the function of the SpaceMate

E300. Stand on the foot pedals and place your hands at a comfortable

position on the handlebars. Slowly move your highest foot forward and follow the natural path of the machine.

Complete one full revolution slowly to verify that the drive train functions properly. Adjust the TENSION

KNOB(21) and verify that it functions properly.

Grasp the pivot tubes on the HANDLEBARS(81, 82) and REAR STABILIZER(3) to move the

SpaceMate

E300, two people are required for moving. Do not use the Pedal Arms to move

the SpaceMate

E300. The Pedal Arms will move and may pinch your hand or fingers.

Adjust the LEVELING CAPS(44) on the REAR STABILIZER(3) so that the SpaceMate

E300 sets on the floor without rocking.

Adjust the STAND(46) on the FRONT STABILIZER(2) so that the stand touches the

equipment mat or floor. Refer to the inset drawing.