User's Manual

GM29 INTEGRATOR’S MANUAL
138
LZT 123 7361 R1A
List of result codes
10.8 ATZ Reset to Default Configuration
This command instructs the DCE to set all parameters to their default
values as specified by the user. Consider hardware configuration
switches or non-volatile parameter storage (if implemented) when using
this command.
ATV1/ATV=1 ATV0/ATV=0 Description
OK 0 Acknowledges execution of a
command
CONNECT 1 A connection has been established;
the DCE is moving from command
state to online data state
RING 2 The DCE has detected an incoming
call signal from the network
NO CARRIER 3 The connection has been terminated
or the attempt to establish a
connection failed
ERROR 4 Command not recognized, command
line maximum length exceeded,
parameter value invalid, or other
problem with processing the command
line
NO DIALTONE 6 No dial tone detected
BUSY 7 Engaged (busy) signal detected
NO ANSWER 8 “@” (Wait for Quiet Answer) dial
modifier was used, but remote ringing
followed by five seconds of silence was
not detected before expiration of the
connection timer
CONNECT
<TEXT>
Manufacturer
-specific
Same as CONNECT, but includes
manufacturer-specific text that may
specify DTE speed, line speed, error
control, data compression, or other
status
Description Command Possible Responses
Execute ATZ •OK
•ERROR
Execute ATZ=<profile> •OK
•ERROR
Show if supported and
list available
parameter range
ATZ=? Z: (list of supported
<profile>s)