User's Manual

GM29 INTEGRATOR’S MANUAL
82
LZT 123 7361 R1A
3.22 AT+CPAS Phone Activity Status
Returns the activity status <pas> of the ME. It can be used to interrogate
the ME before requesting action from the phone.
When the command is executed without the <mode> argument, the
command returns <pas>-values from 0 to 128 (for supported values se
table 1 below). When, on the other hand, the command is executed with
the <mode> argument set to 1, the command may return Ericsson
specific <pas> values from 129 to 255 (for supported values see the
table below).
Test command returns values supported by the ME as a compound
value: refer to GSM 07.07.
Description Command Possible Responses
Execute Phone Activity
Status
AT+CPAS[=<mode>] •+CPAS: <pas>
•+CME ERROR <err>
•OK
•ERROR
Test if the command is
supported
AT+CPAS=? •+CPAS:
(list of supported
<pas>s)
•+CME ERROR <err>
•OK
•ERROR
<pas> Description
0 Ready (ME allows commands from TA/TE)
3 Ringing (ME is ready for commands from TA/TE, but the
ringer is active)
4 Call in progress (ME is ready for commands from TA/TE, but
a call is in progress)
129 In idle state, (operator name/clock/date). This state is a
sub-state to ‘ready’ (0) and has the following definition:
In Idle state, that is, operator, clock and date (is set)
shown on the display
No conversation or data call in progress
No sub-menus shown on the display
4 Only digits, clear, *, NO and # allowed in this mode, not
changing mode
130 Mobile oriented call in progress. This is a sub-state to ‘call
in progress’
131 Mobile terminated call in progress. This is a sub-state to
‘call in progress’
<mode> Description
1 Allows the CPAS to return Ericsson specific <pas> values,
such as 129, 130 and 131