Installation Guide

D D
Glacier
INSTALLATION INSTRUCTIONS
Adjust the operating panel with the screw
at each end.
Raise or lower the operating panel using a
square head screwdriver for both sides.
Adjust the door screen using a square head
screwdriver for both sides, top and bottom.
To attach mortise handle
1. The dimension of the opening must exceed the exterior
dimension of the door frame by 32 mm (1 1/4”) in width and
by 32 mm (1 1/4”) in height.
2. When installing, this product must be squared and levelled.
3. Wedge the frame (see sketch) with 3 wedges between the
structure, the sill and the jambs, and one at the head.
4. Make sure the head, sill and jambs are straight.
5. Fill the space between the door frame and the structure with
insulation material. Be careful, as excessive insulation material
may warp the frame.
6. Seal the interior and exterior perimeter of the door with caulking.
7. Install metal lock keeper into pre-drilled holes in the frame using
latch assembly kit included with your door.
1. Do not paint the vinyl or hardware as this will impair the door from
functioning properly and will void the guarantee.
2. Clean the vinyl with a soft cloth and soap. All abrasive products
will damage the surface nish.
For your comfort, and to prevent
condensation, experts recommend
these humidity values:
MAINTENANCE
INSTALLATION
Professional installation highly recommended
Outside
Temperature
Indoor Maximum
Relative Humidity
-7C 35%
-12C 30%
-18C 25%
-23C 20%
-29C 15%
WEDGE
JAMB
HEAD
SILL
Screw
cap