Product Manual

SAFETY INFORMATION
5
Double Insolated Product
SAFETY INFORMATION
SAFETY INFORMATION
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
detergent. Dish or laundry soap is too thick and will
clog the nozzle of your detergent bottle.
IMPORTANT: Store the power washer indoors to
prevent the water in the unit from expanding under
freezing conditions. When the water freezes and
expands, your power washer will be damaged and
become inoperable. Or, if storing outdoors, it is
recommended you use pump saver (not included) to
protect pumps.
26. NEVER use hot water with your power washer. It
will overheat and damage the high pressure pump.
27. NEVER leave the power washer unattended while
it is powered “ON”.
28. ALWAYS turn the water supply “ON ” before
turning the power washer power to “ON”.
Running the pump dry will cause damage to the
internal components.
29. NEVER use a water supply to your power washer
that exceeds 150 PSI maximum.
30. NEVER disconnect the high pressure hose from the
power washer while the system is pressurized.
31. NEVER permanently engage the trigger
mechanisms on the spray gun.
32. NEVER operate the power washer unless all
components are properly and securely connected.
33. NEVER allow the power washer pump to run for
more than one minute after you have turned off
the water supply. This can cause the motor and
pump to overheat and fail.
34. NEVER use lances or other parts that are not
compatible for this specific Stanley unit.
35. NEVER use an extension power cord since it
defeats the effectiveness of the GFCI and increases
the chance of electrocuting the operator.
36. NEVER spray any electrical outlet with your power
washer.
37. Inspect the power cord before using. DO NOT use
it if it is damaged.
Servicing of a Double-Insulated Appliance
Ground Fault Circuit Interrupter Protection:
This pressure washer is provided with a ground-fault
circuit-interrupter (GFCI) built into the plugs of the
power-supply cord. This device provides additional
protection from the risk of electric shock. Should
replacement of the plug or cord become necessary,
use only identical replacement parts that include GFCI
protection.
In a double-insulated product, two systems of
insulation are provided instead of grounding.
Grounding means are not provided for a double
insulated product, nor should grounding means be
added to the product. Servicing a double-insulated
product requires extreme care and knowledge of the
system, and should only be done by qualified service
personnel.
Replacement parts for a double-insulated product must
be identical to the original parts.
A double-insulated product is marked with the words
“Double Insulation” or “Double Insulated”. Product
may also be marked with symbol shown here.
93902_16ARN027_1600_ENG-FR-SP.indd 5 16/12/23 上午11:12