Product Manual

ASSEMBLY INSTRUCTIONS

OFF/O

ON/I

Slide cord hook holster (D) onto right side, when fac-

ing unit, of power washer unit (C) as shown.

Note: This step does not require any screws.

Soft PVC High Pressure Hose Assembly

Screw Soft PVC high pressure hose (E) clockwise onto

bottom front of power washer unit (C). Pull back collar

and insert o-ring post into water outlet far enough so

collar can thread onto outlet threads until hand tight.

If it takes fewer than six turns you have not properly

tightened the Soft PVC high pressure hose fitting. It is

easier to position the power washer in front of you to

ensure that the threads are started correctly. Failure to

properly tighten Soft PVC high pressure hose will result

in the hose slipping or popping off immediately upon

turning unit on. Do not worry about damage if this

occurs–just reinstall and take extra care when screwing

on the Soft PVC high pressure hose fitting.

Note: DO NOT use pliers or locking pliers to tighten.

Connect the other end of Soft PVC high pressure

hose (E) to spray gun (F) by inserting the silver metal

tip of Soft PVC high pressure hose into the fitting just

ahead of trigger guard. It will lock into spray gun with

a “click”. Confirm hose is locked into spray gun by

slightly pulling on hose. The hose is now securely at-

tached to spray gun.

Note: DO NOT press button on underside of gun

when connecting hose to gun.

To release hose (E) from spray gun (F), press button on

underside of gun toward trigger guard. The hose will

slide out from connection.

93902_16ARN027_1600_ENG-FR-SP.indd 7 16/12/23 上午11:12