User Guide

Instructions to Use Metal Yarn Ball Winder
Place the feeding wire arm between the washer and the base plate.
Position the wire arm so the end loop is behind the small Phillips
screw . This helps lock the wire arm and prevents it from moving. Hand
tighten the butterfly screw to secure the wire arm.
Thread the yarn first through the
distal wire arm , then through the
proximal wire arm, and finally
position it tightly into the cleft of the
bobbin. Begin turning the crank
on the ball winder to start winding.
Any questions please contact us at:
[e-mail]
or
[e-mail]
Tel: [phone]
Copyright © 2012 Stanwood Imports/Oriental Touch
Tightly camp the winder to
the edge of a table
Align the bobbin and the base of the winder at the locations shown by arrows. Push the bobbin all the way
down. With one hand holding the proximal wire arm to prevent the base from rotating, use the other hand to turn
the bobbin clockwise to lock it down.