Owner's Manual

SCREW

SPEED

CONTROL

OUTLET BOX

AFTER ALL WIRES ARE CONNECTED:

( 1 ) Attach wall control unit to outlet box using the

two 6-32 screws provided.

( 2 )Attach wall plate to the switch control front.

! WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside

the outlet box and not pinched between the wall plate and the wall.

! WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible

at the wire connectors, except for the ground wire. Do not operate fan until the blades are

in place. Noise and fan damage could result.

Align Holes

Deco Ring

3. CANOPY INSTALLATION

Push up canopy until two pre-screwed screws on Mounting Bracket are engaged with two key holes on Canopy.

Rotate Canopy slightly until two pre-screwed screws heads are engaged in the narrow end of key holes.

Tighten both screws.

Push Deco Ring up to Canopy, align holes on Canopy withribs on Deco Ring, and push “snap-in”.

Note: Two screws are pre-screwed on Mounting Bracket for Canopy installation.

Key Hole (2)

Canopy

Screw (2)

Canopy