Instruction Manual

PLIT513 REV. - 3/13/14

We have designed a number of brackets for the Half and Split Phantom light that fit specific

vehicles. This instruction sheet applies to those that mount directly to the top of the light.

Half and Split Phantom Mounting

Top Mounted Vehicle-Specific Brackets

3. Remove both the driver and

passenger visor clips from the vehicle.

4. Loosen (LOOSEN, DO NOT REMOVE!!)

the three visor pivot arm screws on one

side of the vehicle with appropriate

screwdriver. (Passenger’s side shown)

1. Remove the two pairs of screws from

each light half as shown to the right.

2. Place your bracket over the holes as pictured below and re-install the screws using the

enclosed #8 washers (P30073-4) between the head of the screw and the bracket. Do

this for both halves of the light, ensuring the brackets are mounted with the forks towards

the outer edge of the light.

Add a washer between

each screw head and

the bracket

PAGE 1
Half and Split Phantom Mounting Top Mounted Vehicle-Specific Brackets We have designed a number of brackets for the Half and Split Phantom light that fit specific vehicles. This instruction sheet applies to those that mount directly to the top of the light. 1. Remove the two pairs of screws from each light half as shown to the right. 2. Place your bracket over the holes as pictured below and re-install the screws using the enclosed #8 washers (P30073-4) between the head of the screw and the bracket.
PAGE 2
5. Slide the forked end of the visor bracket under the visor pivot arm that you just loosened. (Passenger’s side shown) 6. Align the square hole on the other end of the visor bracket with the visor clip hole. (Passenger’s side shown) 7. Replace and tighten visor clip to secure the visor bracket to your vehicle. (Passenger’s side shown) 8. Tighten the screws on the visor arm to hold the visor bracket and light in place. (Passenger’s side shown) Note: Light not shown in this picture for clarity.