User guide

ManualsBrandsStar Headlight & Lantern ManualsLightingULB18 Lineum Dual-Color Half-Phanto Interior LED Lightbar

-11-

NOTICE

Due to continuous product improvements, we must reserve the right to change any specifications and information,

contained in this manual at any time without notice. Star Headlight & Lantern Co., Inc. makes no warranty of any kind

with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a

particular purpose. Star Headlight & Lantern Co., Inc. shall not be liable for errors contained herein or for incidental or

consequential damages in connection with the furnishing, performance, or use of this manual.

PLIT521 REV - 9/11/14

IMPORTANT: Please read all of the following instructions before installing your new warning light.

Lineum Star Half Phantom

Dual Color Undercover Interior LED Lightbar

Model ULB18

Summary of content (6 pages)

PAGE 1
Lineum Star Half Phantom ® NOTICE Due to continuous product improvements, we must reserve the right to change any specifications and information, contained in this manual at any time without notice. Star Headlight & Lantern Co., Inc. makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Star Headlight & Lantern Co., Inc.
PAGE 2
NOTICE Due to continuous product improvements, we must reserve the right to change any specifications and information, contained in this manual at any time without notice. Star Headlight & Lantern Co., Inc. makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Star Headlight & Lantern Co., Inc.
PAGE 3
Operating Instructions Gasket Installation Main control of this light is done though the wires in the harness. They should be connected to +12VDC through several switches (user supplied) as described in the Wiring section. 1. Before installing any of the brackets, slide the enclosed rubber channel over the front edge of the baffle. Level 1 Flashing Mode (Orange w/Green) This is usually intended as a slower, less urgent mode typically used when parked.
PAGE 4
Program Mode (Cloning) Program Mode High-Low/Pattern Traffic Director/ Takedown 2. Connect the second light to the programmed unit using a special telephone-type cable (P/N SWH-140 available from the manufacture upon request) between the two communications ports. Phase Programming Communication Port Head Enable Programming CAUTION: Take extreme caution not to over tighten the screws!!! Over tightening of the screws can strip the holes. CTS 1. Program the first light as previously described.
PAGE 5
Programming (CONT'D) Wiring Please note: Because this is a 4-head unit, some options listed below will appear identical to others and some options will disable ALL of the heads. For proper installation and full operability, this light requires a 20A ignition switched power source, connections to the negative terminal of the battery, and 4-6 external switches rated for a minimum 1A (user supplied).
PAGE 6
Programming (CONT'D) Programming Programming is optional. If the default settings are acceptable, skip to the Operation section. If you will be changing any of the options on your lightbar, this should be done prior to installation.