Fitness Electronics User Manual

620-7991 Rev 002

STEP 13.

Note: If the iPod cable comes pre-installed on the cradle,

skip this step.

Take the iPod® cable from the kit. Install the

cable into the iPod® cradle on the front side of

the display console by removing the plug from

the cradle then inserting the cable through open-

ing. Make sure cable is aligned properly with the

display plastics. Press firmly to ensure the cable

is seated into the cradle.

STEP 14.

With the center console now installed, it is time

to attach the USB cable, center console ribbon

and the iPod® cable. Take the USB cable from

the center console and attach it to the CCB J14

connector on the display board. Next take the

center console ribbon cable and attach it to the

display PC board. Then take the iPod® cable

from the base of the mount to the center con-

sole. Tie the iPod® cable to the plastic using the

3.5” tie wrap.

STEP 15.

Next replace the bottom cover. Using a #2 Phil-

lips head screwdriver, replace the (4) screws

that hold the bottom side of the display console

on. Then plug in the CSAFE cable to the back of

the display board.

Make sure pin one on the cable is connected to pin one on the board.