Fitness Electronics User Manual

23 620-7991 Rev 002
STEP 15.
Remove the nut and washer from the F-Type
connector on the end of the coax cable you fed
down the treadmill neck, then put connector
through the mounting bracket. Replace the nut
and washer, and tighten the nut snugly.
Next replace mounting bracket into the neck,
using the screws retained from previous step.
Tighten with a #2 Phillips screwdriver.
STEP 14.
Go to the base of the treadmill neck. Using a #2
Phillips screwdriver, remove the (2) screws that
hold in the RF cable Mounting Bracket. Retain
the screws for later use.
STEP 16.
Replace the bottom back plastic cover. Using a
#2 Phillips screwdriver insert the (6) screws, re-
tained from earlier step, into the plastic and
tighten snug.
Caution: Do not over tighten screws.
STEP 13.
• Plug the center console’s ground ca-
ble into the quick disconnect tab on the back
display mount.
• Connect the keypad tail to the ke y-
pad connector on the display board.
• Connect the interface cable to the In-
terface connector J11 on the display board.
3
2
1