Fitness Equipment User's Manual

Page 8 SPINNER
®
OWNER’S GUIDE
SPINNER
®
NXT ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your SPINNER
®
NXT.
UNPACKING
Prepare the area that you will be unpacking and assembling the bike to be free from debris that may cause damage. Observe all safety precautions and
care while unpacking and assembling the bike. Position the shipping carton so the “Heavy End” logo is located at the bottom. Open the top of the
carton and fold back all four flaps. Carefully tilt the box forward so that the box may be lifted to expose the bike. Remove all parts from the shipping
carton and foam inserts, and verify that the following parts are included in your shipment:
NXT Parts List
Description Qty. Description Qty.
Main Frame Assembly 1 Rear Leg Assembly 1
Handlebar Post 1 M10x1.5, 55mm Button Head Screw 4
Handlebar w/ Grip & Water Bottle Holders 1 M10x1.5, 65mm Button Head Screw 4
M8x1.25, 16mm Flat Head Screw 2 M10x1.5 Nyloc Hex Nut 8
M8x1.25, 16mm Socket Set Screw 1 10mm Washer, Flat 16
Seat Post 1 Wrench Hex, 5mm 1
Seat Slider Assembly w/ Saddle 1 Wrench Hex, 4mm 1
Pedals (set of two) 1 Multi-Wrench 1
Front Leg Assembly w/ Transport Wheels 1 Spare Parts Kit (includes brake pad and pedal straps) 1
Spare Parts Kit- Save the box of spare parts in a safe place so you have service parts when needed in the future.
Take time now to enter your Spinner
®
NXT serial number in the space below (serial number is located on the bottom cross
member). If parts are missing, or if you have any operational questions, please call Star Trac’s Service department at [phone]; have your serial
number ready.
Serial No._____________________________________________
NOTE: If you are missing any of the parts listed above, inspect the packing material and the box for items that may have been overlooked.
If parts are missing, or if you have any product questions, please call Star Trac’s Service Department at [phone], p lease have your Spinner’s
serial number ready.
CAUTION: Damage to the bike during assembly is not covered as part of the limited Star Trac® warranty. Take care not to drop or lean the bike on
the handle bar pop-pin. Carefully stand the bike up in the normal upright position on a stable surface so it will not tip over during assembly.