PLATE COMPACTOR ITEM: 61006/61007 OWNER’S MANUAL AND SAFETY INSTRUCTIONS SAVE THIS MANUAL: KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY, OPERATING, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES.
IMPORTANT SAFETY INFORMATION GENERAL SAFETY WARNINGS Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
IMPORTANT SAFETY INFORMATION Operate the plate compactor on flat, level surfaces only. Turn the engine OFF when the compactor is not in use. DO NOT operate or service this machine before reading this entire manual. Never operate this equipment without proper protective clothing, shatter proof ANSI-approved glasses, steel-toed boots, and other protective job site devices. NEVER operate the equipment while under the influence of medication, drugs or alcohol.
OPERATION PRE-START INSPECTION: The following Pre-start-up inspection must be performed before the start of each work session or after every four hours of use, whichever is first. If any fault is discovered, the compactor must not be used until the fault is rectified 1. Thoroughly inspect the compactor for signs of damage. Check components are present and secure. Pay special attention to the belt drive safety guard fitted between the engine and the vibrator unit. 2.
OPERATION 5. Taking a firm hold of the control handle with one hand,grasp the recoil starter handle with the other. Pull the recoil starter until engine esistance is felt, then let starter return. 6. Taking care not to pull the starter’s cope fully out, pull the starter handle briskly. 7. Repeat until the engine fires. 8. Once the engine fires gradually,set the choke lever to the OFF position by moving it to the right. 9.
CARE AND MAINTENANCE Check the oil level in the motor crankcase daily. Check the vibrator oil level weekly. Inspect the rubber anti vibration mounts for wear or deterioration. If the optional water tank is fitted inspect the water hose and its connections to ensure that they do not leak. Clean the underside of the plate regularly to prevent a build up of material. Inspection and other services should always be carried out on hard and level ground with the engine shut down.
CARE AND MAINTENANCE CHANGING VIBRATOR OIL When changing the vibrator oil, remove the drain plug located at the bottom-right of the vibrator, and simply tip the compactor to drain the oil. Note that the oil will drain more easily while it is hot. Replace the oil with 200ML of 10W-3C motor oil. AIR FILTER 1. The air filter element should be cleaned because a clogged air cleaner can cause poor engine starting, lack of power and shorten engine Iife substantially. 2.
SPECIFICATIONS MOTOR: MODEL #61006 Chinese Petrol Engine, 4.8 kW output. MODEL #61007 Petrol, Honda GXl60, 4.0 kW output. GOVERNED SPEED: 3,500r/min DRIVE BELT: 1 x ’A’ section v belt VIBRATOR FREQUENCY: 5,500 Vibration/min VIBRATOR CENTRIFUGAL FORCE: 13.0kN OPERATION MASS: 84kgs ACOUSTIC NOISE (ACCORDING TO 2000/14/EC Hand-Arm-Vibration (as per ISO8662, Part 1, m/ s2) 4-9 NAMEPLATE The following bearing are sealed. Centrifugal clutch-grease lubricated Vibrator-oil bath lubricated. TRANSPORTATION 1.
TROUBLESHOOTING 8
PARTS DIAGRAM 9
PARTS LIST 10
PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.