Use and Care Manual

- 4 -
Inspection and other services should always be
carried out on hard and level ground with the engine
shut down．
Inspection and Maintenance Service Tables．
To make sure your plate compactor is always in good
working condition before using ， carry out the
maintenance inspection in accordance with Tables 1
through 3．
TABLE 1．MACHINE INSPECTION
Item
Hours of Operation
(Starting check)
Every 8 hours(every day)
Loosened of lost screws
Every 8 hours(every day)
Damage of any part
Every 8 hours(every day)
Function of controlling system
part
Every 8 hours(every day)
Vibrator oil check
Every 100 hours
Vibrator oil replacement
Every 200 hours
V-belt(clutch)check
Every 200 hours
TABLE 2．ENGINE CHECK
(For details, see separate engine Manual)
Item
Hours of Operation
Leakage of oil fuel
Every 8 hours(every day)
Tightness of fastening
Threads
Every 8 hours(every day)
Engine oil check and
replenishment
Every 8 hours(every day)
(Replenish to specified
Max．level)
Engine oil
replenishment
At first 20 hours．Then every
100 hours
Air cleaner cleaning
Every 50 hours
CAUTION：
These inspection intervals are for
operation under normal
conditions．Adjust your inspection
intervals based on the number
hours plate compactor is in use,
and particular working conditions．
CAUTION：
Fuel piping and connections should
be replaced every 2 years．
Daily Service
● Check for leakage of fuel or oil．
●Remove soil and clean the bottom of compaction
plate．
●Check engine oil．
Check for loose screws including tightness．See Table
3 below(tightening torque),for re-tightening．
TABLE 3.
TIGHTENING TORQUE(in．kg/cm)Diameter
Changing Vibrator Oil
when changing the vibrator oil，remove the drain plug
Material
6mm
8mm
10mm
12mm
14mm
16mm
18mm
20mm
4T
70
150
300
500
750
1100
1400
2000
6-8T
100
250
500
800
1300
2000
2700
3800
11T
150
400
800
1200
2000
2900
4200
5600
*
100(6mm) 300-350(8mm) 650-700(10mm)
* (In case counter-part is of aluminum
(Threads in use with this machine are all right handed)
Material and quality of material is marked on each bolt, and
screw.
Changing Vibrator Oil
When changing the vibrator oil, remove the drain plug
located at the bottom-right of the vibrator, and simply
tip the compactor to drain the oil．Note that the oil will
drain more easily while it is hot．Replace the oil with
200ML of 10W-3C motor oil．
Air Filter
1.The air filter element should be cleaned because a
clogged air cleaner can cause poor engine starting,
lack of power and shorten engine Iife substantially．
2.To clean or replace air filter loosen the wing nut on
the air filter housing(Figure 1)，remove the cover
and take out air filter cartridge．If only cleaning of
the air filter is desired blow through the air filter
cartridge from the inside, moving a jet of dry
compressed air up and down until all dust is
removed．
CAUTION：
NEVER attempt to check the V-belt
with the engine running．Severe
injury can occur if your hand gets