REVERSIBLE PLATE COMPACTOR 61011 Owner’s Manual Questions? Problems? Please call our customer support: (909) 628 4900 Mon-Fri 9am to 3pm PST WARNING To reduce the risk of injury,all operators and maintenance personnel must read and understand these instructions before operating ， changing accessories ， or performing maintenance about this power equipment. All possible situations cannot be covered in these instructions．Care must be exercised by everyone using，maintaining or working near this equipment.
CONTENTS INTRODUCTION Introduction………………………………………………………2 Applications………………………………………………………2 Functions and controls …………………………………… ……3 Accessories………………………………………………………3 For safety operation ……………………………………………3 Hazards and risks……………………………………………… 4 Operation………………………………………………………4-9 Care and preventive maintenance……………………………9 Service………………………………………………………… 9 Specifications…………………………………………………10 Thank you for your selection of this equipment.
Air-cooled Single cylinder Engine is amounted as power source and Centrifugal Clutch is fixed on engine output shaft．Petrol Engine(2 cycle，4 cycle)and Diesel Gasoline Engine can be mounted as option．Centrifugal Clutch engages by running up the engine and engine R.P.M.
HAZARDS AND RISKS NEVER allow any person to operate the machine without adequate instruction． ENSURE all operators read ， understand and follow the operating instructions． SERIOUS INJURY could result from improper or careless use of this machine Plate compactors are heavy units and should be positioned by two people of appropriate strength ． Using the lifting handles provided on the machine, along with correct lifting techniques． ! MECHANICAL HAZARDS DO NOT operate the machine unless all protective guards a
For more information on starting and correct operating procedures of the motor,refer to the motor operation manual sup- plied with the unit． Increase the motor speed to the maximum setting using the hand throttle lever,before commencing compacting． The machine should be controlled by grasping the handle with both hands and applying restraint to control the forward motion.
2-4．Stop engine without fail before replenishing fuel tank.
!CAUTION Do not pull the rope all the way and do not take your hand off the pulled knob but slowly return it original position． 3-8．After starting up the engine，be sure to perform a warm up the engine，be sure to perform a warm up run for 2 to 3 minutes．This should be performed without fail,particularly during winter season． 4．Operation 4-1．As the engine warms up,gradually move the choke lever to the OPEN position Fig-8 4-2．Move the speed control lever from the LOW to the HIGH position．When the engine speed
6．Shutdown To stop the engine in an emergency，turn the stop switch to the OFF position． Under normal conditions, use the following procedure： 6-1．Set the speed control lever at the low speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping． 6-2．Tum the stop switch to the OFF position．Fig-12 6-3．Close the fuel cock． Fig-13 7．Service & storage ! CAUTION Flammable liquid：Stop engine and do not smoke or allow work in immediate area when refueling．Fire or explosion could resu
B．Remove spark plug，clean and adjust the spark plug gap to 0.6-0.7mm(0.02-0.03 in.).
! CAUTION ! CAUTION Inspection and other services should always be carried out on hard and level ground with the engine shutdown． Fuel piping and connections should be replaced every 2 years. Inspection and Maintenance Service Tables． 1． To make sure your plate compactor is always in good working condition before using ， carry out the maintenance inspection in accordance with Tables 1 through 3． TABLE1.
SPECIFICATIONS Model 61011 Engine Air-cooled, single cylinder, 4-storke Engine type Petrol,Loncin 200F Power Hp 6.
