Replacement Part List

7
!CAUTION
Do not pull the rope all the way and do not
take your hand off the pulled knob but slowly
return it original position．
3-8．After starting up the engine，be sure to perform a
warm up the engine，be sure to perform a warm
up run for 2 to 3 minutes．This should be
performed without fail,particularly during
winter season．
4．Operation
4-1．As the engine warms up,gradually move the choke
lever to the OPEN position Fig-8
4-2．Move the speed control lever from the LOW to the
HIGH position．When the engine speed reaches
approximately 2,300-2,600 PRM,the centrifugal
clutch engages．If the engine speed increased very
slowly,it is possible that the clutch can slip．Do
not operate the speed control lever slowly．
Fig-9,10
OIL ALERT SYSTEM
The Oil Alert System is designed to prevent engine
damage caused by an insufficient amount of oil in the
crankcase．Before the oil level in the crankcase can fall
below a safe limit the Oil Alert System will
automatically stop the engine(the engine switch will
remain in the ON position)．
!NOTICE
If the engine stops and will not restart,check
the engine oil level．
4-3．When compacting asphalt,it is advisable to paint
the bottom face Of the vibrating plate with diesel
fuel．
This will assist in preventing the plate from
sticking to the as halt．
4-4．When shutting off the vibrator,turn the speed
control lever from the HIGH to LOW position．Do
not move the speed control lever slowly．
5．Transportation
5-1．Be sure to stop the engine while transporting．
5-2．Screw up the fuel tank cap securely and close the
fuel valve to avoid fuel leaking．
5-3．1n transportation by car,fix machine securely not to
move nor to fall down．
In case Of driving for long distance or at off-road,
tank out fuel from tank．