Replacement Part List

8
6．Shutdown
To stop the engine in an emergency，turn the stop
switch to the OFF position．
Under normal conditions, use the following procedure：
6-1．Set the speed control lever at the low speed
position and allow the engine to run at low speed
for 2 or 3 minutes before stopping．
6-2．Tum the stop switch to the OFF position．Fig-12
6-3．Close the fuel cock． Fig-13
7．Service & storage
! CAUTION
Flammable liquid：Stop engine and do not
smoke or allow work in immediate area when
refueling．Fire or explosion could result from
flames or sparks．
Moving parts：Shutdown engine before
performing service or maintenance．Contact with
moving parts can cause serious injury．
High temperature：Allow machine and engine to
Cool before performing service 0r maintenance．
Contact with hot components can cause serious
burn．
7-1．Dail Service
A．Remove mud, dirt,etc., from the unit．
B．Clean bottom face of the vibrating plate．
C．Check the air cleaner element and clean if
necessary
D．Check all nuts,bolts, and screws for tightness
and re-tighten as necessary．
7-2．Weekly Service
A．AIR CLEANER SERVICE Fig-14
Dirty air cleaner element will cause starting
difficulty．power loss，engine malfunctions, and
shorten engine life extremely．
Keep the air cleaner element clean．
URETHANE FOAM ELEMENT
Remove the element and wash it in kerosene or
dieseI fuel．Then saturate it in a mixture of 3 parts
kerosene or diesel fuel and I part engine oil．
Squeeze the element to remove the mixture and
install it in the air cleaner．
URETHANE FOAM DUAL STRUCTURE
1．Clean the urethane foam in the same way as
described above．
2．Wash the element in kerosene or diesel fuel．
Saturate it in a mixture of 3 parts kerosene or
diesel fuel and l part engine oil. Shake off
excessive oil and re-install．