SURFACE FINlSHING SCREED 61008/61013 Owner’s Manual
WARNING To reduce the risk of injury, all operators and maintenance personnel must read and understand these instructions before operating，changing accessories，or performing maintenance about this power equipment. All possible situations cannot be covered in these instructions．Care must be exercised by everyone using，maintaining or working near this equipment.
CONTENTS Introduction……………………………………3 Applications……………………………………3 Functions and controls…………………………3 Accessories……………………………………3 Hazards & risks……………………………3-4 Operation………………………………………4 C a r e a n d p r e v e n t i v e m a i n t e n a n c e … … … … … … 4 Service…………………………………………4 Cleaning storage………………………………4 Specifications…………………………………5 Troubleshooting………………………………56 3
INTRODUCTION Thank you for your selection of Might equipment. General Safety Instructions Operation of Power Equipment for HAZARDS AND RISKS the NEVER allow any person to operate the machine without adequate instruction． The goal of Might is to produce power equipment that helps the operator work safely and efficiently. The most important safety device for this or any tool is the operator. Care and good judgment are the best protection against injury. All possible hazards cannot be covered here.
been spread,start the motor and manually pull the beam along the slab．Make sure that there is always a continuous surcharge along the entire length of the leading edge． petrol when refueling．Spilled petrol or petrol vapour may ignite．If spillage occurs，ensure that the area is dry before starting the motor． Generally one steady pass with the screed should be enough to compact and level the concrete． ENSURE that the fuel tank cap is securely fitted after refueling． Vibration of the concrete is still neces
SPECIFICATIONS Without blades SF and SF-1 are with adjustable handle． Model 61013 Engine 61008 Air-cooled, 4-cycle Air-cooled, 4-cycle Chinese Petrol Engine Petrol,Honda GX35 Power kw (hp) 0.65(0.9) 1.0(1.3) Weight kg(lbs) 12.7(28.0) 12.7(28.0) Engine Type Weigh of Blades The total weight of the machine should be the weight of engines assembly plus weight of blades． Blade Size m(ft) 1.22(4) 1.8(6) 2.44(8) 3.0(10) 3.66(12) 4.47(14) Weight kg(lbs) 2.9(6.4) 4.36(9.6) 5.81(12.8) 7.27(16.
Difficult to start,“fuel is available, but no SPARK at spark plug”.
