Replacement Part List

6
OPERATION
When compacting asphalt, it is advisable to paint the bottom face of the
vibrating plate with diesel fuel. This will assist in preventing the plate from
sticking to the as halt. When shutting off the vibrator, turn the speed
control lever from the HIGH to LOW position. Do not move the speed
control lever slowly.
Transportation
Be sure to stop the engine while transporting. Screw up the fuel tank cap
securely and close the fuel valve to avoid fuel leaking. In transportation
by car, x machine securely not to move nor to fall down. In case of
driving for long distance or at off-road, tank out fuel from tank.
Shutdown
To stop the engine in an emergency, turn the stop switch to the OFF
position. Under normal conditions, use the following procedure. Set the
speed control lever at the low speed position and allow the engine to run
at low speed for 2 or 3 minutes before stopping. Turn the stop switch to
the OFF position. Close the fuel cock.
CAUTION: Flammable liquid: Stop engine and do not smoke or allow
work in immediate area when refuelling. Fire or explosion could result
from ames or sparks.
Moving Parts: Shutdown engine before performing service or
maintenance. Contact with moving parts can cause serious injury.
High Temperature: Allow machine and engine to cool before
performing service 0r maintenance. Contact with hot components can
cause serious burns.
Daily Service
A. Remove mud, dirt, etc., from the unit.
B. Clean bottom face of the vibrating plate
C. Check the air cleaner element and clean if necessary
D. Check all nuts, bolts, and screws for tightness and re-tighten
Weekly Service
AIR CLEANER SERVICE: Dirty air cleaner element will cause starting
difculty, power loss, engine malfunctions, and shorten engine life
extremely. Keep the air cleaner element clean.
URETHANE FOAM ELEMENT: Remove the element and wash it in
kerosene or dieseI fuel. Then saturate it in a mixture of 3 parts
kerosene or diesel fuel and I part engine oil. Squeeze the element to
remove the mixture and install it in the air cleaner.
URETHANE FOAM DUAL STRUCTURE: Clean the urethane foam in
the same way as described above. Wash the element in kerosene or
diesel fuel. Saturate it in a mixture of 3 parts kerosene or diesel fuel and
1 part engine oil. Shake off excessive oil and re-install.
AIR CLEANER
FUEL COCK
STOP SWITCH
SPEED CONTROL LEVER
CHOKE LEVER
SPARK PLUG: Remove spark plug, clean and adjust the spark plug
gap to 0.6-0.7mm (0.02-0.03 in.). drain the motor oil of the engine and
replace with new specied oil. NOTE: When the engine is new, the rst
oil change must be made after 20 hours of operation.