Replacement Part List

MAINTENANCE

Monthly Service

Change the oil in the vibrator assembly. Storage When storing the compactor

for long periods after operation. Thoroughly drain the fuel from the fuel tank fuel

pipe and carburetor. Pour a few drops of motor oil into the cylinder by removing

the spark plug. Rotate the engine several times by hand so that the cylinder

interior is covered with oil. Clean the outer surface of the machine with an oil

moistened cloth. Cover the unit and store in a humidity-free, dust-free area.

Care and Preventative Maintenance

Check the oil level in the motor crankcase daily. Check the vibrator oil level

weekly. Inspect the rubber anti vibration mounts for wear or deterioration.

Clean the underside of the plate regularly to prevent a build up of material.

Service

Change the oil in the motor crankcase regularly to minimise wear. Inspect, clean

and/or replace the motor air cleaner regularly, particularly when operating in a

dusty environment. Inspect,clean and/or replace the spark plug regularly Check

all fasteners for tightness as the machine is subject to vibration. Check vee belt

tension, wear and that it is running true, adjust or replace as required.

Vibrator Oil Check

1. Place the plate compactor horizontally on a at surface. Make sure the

compactor is level when checking the oil in the vibrator assembly.

2. Check vibrator oil level by removing the plug(vibrator oil gauge)as shown in

The oil level should be up to the oil plug. If oil is required, replace using SAE

motor oil, as suggested in the table on page 3.

3. When changing the vibrator oil, remove the drain plug, and simply tip the

compactor to drain the oil. Note that the oil will drain more easily while it is hot.

Bearings

The following bearings ate sealed: Centrifugal clutch-grease lubricated Vibrator-oil bath lubricated

Finish

The machine is nished in gold equipment enamel, the handle in black baked enamel. Exposed metal

surfaces are zinc electroplated for corrosion protection.