Replacement Part List
OPERATING THE DEVICE
5
Always wear safety glasses, gloves and shoes as well as suitable clothing when
operating this log splitter. Never wear jewelry, or loose clothing and be sure to tie
long hair back so as not to get tangled in moving parts.
Keep hands and feet clear of the ram and wedge at all times.
Keep away from ammable liquids and gases before starting the machine.
1. Place the log splitter on a sturdy, level surface. Block the wheels to prevent movement of the log splitter
during operation.
2. Make sure the handle is free of oil, grease and resins.
3. Oil the wedge and the top of the beam for smoother operation.
4. Ensure the equipment is in safe working condition. Operate the unit without loading to make sure it is
working normally. Check all nuts, bolts and hydraulic ttings are tight. Check the switch, power cable and
plug for damage. Check all safety shields are in proper position.
5. Check that the outlets main voltage and frequency match the data stated in the model plate or technical
specications in this manual.
6. Plug in the power cable and switch on the motor. NEVER use an extension cord longer than 25 feet. The
power supply to this log splitter must have a protection device (circuit breaker) for over or under voltage.
7. Place a log on the beam against the push plate. Make sure the log is securely on the beam and up
against the push plate. Logs should be cut with square ends and to a maximum length of 20” in advance.
Always use extra care when splitting logs with unsquare ends.
8. Two controls must be activated to operate the log splitter. The hydraulic control lever and the On/Off push
button must be held during the splitting process. If either control is released, the log splitter will stop working.
9. Loosen the bleed screw one or two turns if necessary.
10. Depress and hold the On/Off push button with your right hand and allow the motor to cycle up to
speed.
11. Push down the hydraulic control lever;
12. Release the On/Off button and the control lever when the log is split, the push log will then retract.
REPLACING HYDRAULIC FLUID
Note: Change hydraulic uid after every 100 hours of use.
Note: Be sure to unplug the power cord before replacing hydralic uid.
1. Place a large pan under the motor end of the log splitter.
2. Use the included hex wrench to loosen the uid drain bolt and remove the bolt with the attached
dipstick.
3. Raise the splitting wedge end of the log splitter to allow the uid to drain into the pan. Lower the splitter
when it is empty.
4. Dispose of the old hydraulic uid in accordance with local regulations.
ASSEMBLY AND OPERATION