Instruction manual

Instruction Manual

3. Place the 2.5” SATA drive into the bay (label side down) and slide the drive onto the

SATA connector. Make sure the drive is fully seated.

CAUTION: To use AES encryption, the drive must be initialized and formatted after

setup. Do not place a drive containing data you wish to encrypt into the enclosure. The

data must be copied over after the enclosure has been setup.

4. Place the back panel back onto the enclosure and fasten using the small screws.

5. With the enclosure fully assembled, connect the USB 3.0 cable from the enclosure to

a USB port on the host computer system.