Operation Manual

" 





4. Install the Seat

Slide Seat Slider into Seat Post.

Disengage pop-pin by loosening then pulling away from the frame.

While still holding onto the pop-pin, install the seat post into the

frame and lower it to the lowest position and tighten the pop pin

securely once again.

Test the seat slide for proper operation and full travel.

Step 4A Step 4B

5. Install the Pedals

NOTE: The pedal shafts are marked “R” and “L”. Trying to install the

pedals on the wrong side may damage the pedal and the crank arm take

caution to attach the pedals to the correct side of the bike.

Install the pedals on the pedal cranks using a 15mm

open-end wrench and tighten securely.

Turn the left pedal spindle counterclockwise when

threading into the left crank arm; turn the right pedal

spindle clockwise when threading into the right

crank arm.

Step 5

You have now completed the assembly of your SPINNER

ELITE / PRO

!Attention!

Crank bolt must be re-torqued after the first 10 hours of use. Refer to Preventive Maintenance section of this manual.

