Operating Instructions and Installation Instructions

STEP #2 - ASSEMBLE SIDE FRAMES:
1. Locate the SIDE FRAME LEFT, AND SIDE FRAME RIGHT as shown below.
2. As shown slide SIDE FRAME LEFT into STEP #1 ASSEMBLY. At each tube joint loosely Install three (M8 X 25MM,
BUTTON HEAD BOLTS), and three (M8, FLAT WASHERS) do not tighten at this time.
3. As shown slide SIDE FRAME RIGHT into STEP #1 ASSEMBLY. At each tube joint loosely Install three (M8 X
25MM, BUTTON HEAD BOLTS), and three (M8, FLAT WASHERS) do not tighten at this time.
4.Using a 5MM hex key tighten all (M8 X 25MM, BUTTON HEAD BOLTS) from STEP #1 and STEP #2 to specified
torque setting. Note: Each tube joint will have three bolts, one located on top, bottom, and side.
Page 13
STEP #2 Completed