Operating Instructions and Installation Instructions

STEP #5: INSTALL KNEE PAD ASSEMBLY, SUPPORT BEAMS
1. Install the SUPPORT BEAM using FOUR (M8 X 25MM, BUTTON HEAD SCREWS) four (M8,FLAT WASHERS).
Tighten all the screws at this time.
2. Repeat steps 1 to install the another SUPPORT BEAM as shown below.
3. Insert the CHEST PAD into PAD FRAME make sure the holes face the handle bar, align the pop pin of handle bar and
fixed the KNEE PAD as shown below. Note: Before you use the machine, you can adjust the position of the CHEST
PAD ASSEMBLY according to your need.
Page 16
STEP#5:Completed