User manual

4.2 Mounting the inverter

Fastening the mounting plate

Screw the mounting plate to the mounting surface using 4

screws:

n Use screws (and dowels etc.) appropriate for the weight of

the inverter.

n The mounting plate must lie flat on the mounting surface

and the metal strips at the sides must point forwards (Fig.

left).

n Install the mounting plate vertically with the retaining plate

① at the top (example in Fig. left).

—————————————————————————

Notice

More information on determining the optimum position for the

mounting plate is provided in the attached information sheet and in

the Appendix under

Mounting

—————————————————————————

For Australia only: Mask off the

Protection Class II

symbol on the type plate.

Note

When the inverter is used in Australia, the national regulations do not permit the Protection

Class II symbol to be displayed on the type plate. The inverter is therefore supplied with a small

sticker in the same bag as the AC plug.

Completely cover the

Protection Class II

symbol using the small sticker provided, as shown in

Fig. 6.

Fig. 6: Position of the sticker for covering the Protection Class II symbol

747.431 | Z08 | 2014-01-31

104