User manual
2 General information
2.1
General safety instructions
n This document is part of the product.
n Install and use the device only after reading and understanding this document.
n Always perform the measures described in this document in the sequence specified.
n Keep this document in a safe place for the entire service life of the device. Pass the document
on to subsequent owners and operators of the device.
n textvar object does not exist
n textvar object does not exist
n textvar object does not exist
:
– Device (not functioning, visible damage, smoke, penetration of liquid etc.)
– textvar object does not exist
– textvar object does not exist
Do not switch the system on again before
– the device has been repaired by a dealer or the manufacturer,
– damaged cables or solar modules have been repaired by a technical specialist.
n textvar object does not exist
n Do not open the casing: Risk of death. Invalidation of the guarantee.
n Factory labels and markings must never be altered, removed or rendered unreadable.
n textvar object does not exist (e.g. external data logger). textvar object does not exist.
Safety instructions on the device
4
5
1
2
3
10min
Isoler les deux sources
avant toute
intervention
Attention
Présence de deux sources
de tension
- Réseau de distribution
- Panneaux photovoltaïques
S/N: 746867XG001155550005
①
Dangerous voltages can remain present on the compo-
nents up to 10 minutes after switching off the DC circuit
breaker and the line circuit breaker.
②
Warning. There are 2 voltage sources present: power grid,
solar modules.
③
Disconnect both voltage sources from the device before
working on the device: the solar modules via the DC cir-
cuit breaker and the power grid via the line circuit
breaker.
④
Read and follow the instructions!
⑤
Serial number as a barcode and in plain text
GB
747.431 | Z08 | 2014-01-31
80