User manual

Backlighting

n off

n automatic: switches on for 30 seconds when a button is

pushed

n Grid feed:

–

Not feeding

: switches on for 30 seconds when a button is

pushed; then switches off

–

Feeding

: switches on for 30 seconds when a button is

pushed; then dims

TCP/IP network

Notice

–

A prerequisite for this is that you know the parameters required for setting up the TCP/IP net-

work connection. Consult (further) technical professionals if required.

–

DHCP is activated in the device ex-works. This allows automatic integration of the device in

most networks.

Network settings, required for network communication, e. g. with

an Internet portal:

n DHCP: Switch DHCP on/off

n IP address: IP address of the inverter

n Subnet mask: Subnet mask of the inverter

n Gateway: IP address of the network gateway

n DNS-Adresse: IP address of the DNS server

n Connection test: Tests the Internet connection and then

displays the result

3.3.4 Service menu

The following section describes the service menu items. Some items have password protection; see

also Fig. in

Ä 5.1, p. 115

. You can obtain the password from our technical support department;

see

Ä p. 145

ATTENTION!

Risk of reduced yields. Inverter and grid parameters can be changed in the service menu. The

service menu may only be used by technical professionals who can ensure that the changes do not

contravene the applicable regulations and standards.

747.431 | Z08 | 2014-01-31