Use and Care Manual

[e-mail]
2
1-800-348-5004
SPECIFICATIONS
IMPORTANT SAFETY INFORMATION
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow instructions listed below may result in serious injury.
SAVE THESE INSTRUCTIONS
1. Keep bystanders, children, and visitors away while operating the Vacuum Pump.
Distractions can cause you to lose control. Protect others in the work area from injury.
2. Stay alert. Watch what you are doing, and use common sense when operating the Vacuum
Pump. Do not use the tool while tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating the tool may result in serious personal injury.
3. Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair,
clothing, and jewelry away from moving parts. Loose clothes, jewelry, or long hair can be
caught in moving parts.
4. Do not overreach. Keep proper footing and balance at all times. Proper footing and balance
enables better control of the tool in unexpected situations.
5. Use safety equipment.
Wear ANSI-approved safety glasses underneath a full face safety shield. Nonskid safety shoes,
hard hat, or hearing protection must be used for appropriate conditions.
6. Do not force the tool. Use the correct tool for your application. The correct tool will do the
job better and safer at the rate for which it is designed.
7. Store idle tools out of reach of children and other untrained persons. Tools are dangerous
in the hands of untrained users.
8. Maintain tools with care. Keep tools dry and clean. Properly maintained tools are less likely
to bind and are easier to control. Do not use a damaged tool. Tag damaged tools “Do not use”
until repaired.
9. Check for misalignment or binding of moving parts, breakage of parts, and any other
condition that may affect the tool’s operation. If damaged, have the tool serviced before
using. Many accidents are caused by poorly maintained tools.
10. Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on another
tool.
Gauge Range
0-30 IN. of mercury (in Hg)
0-760 torr