Instructions / Assembly

ManualsBrandsSteel Glide ManualsTools & Hardware27 in. 8-Drawer Tool Chest and Cabinet Set

ASSEMBLY

INSTALL THE CASTERS

Carefully lay bottom cabinet on its back.

Position the two rigid casters (I) on one side and

position the two swivel casters with brakes (H) on the other side.

Insert the 16 M X (G) Hex bolts through the 16 washers (M)81.25

Tighten securely.

INSTALL THE SIDE HANDLES

Install the side handles on the bottom cabinet and the()C

top chest to make it easier to lift and move the

product.

Position the side handles ()C

over the holes and attach with the 24

MX (B)61.0 Hex bolts provided.

Tighten securely.

ASSEMBLY

TOOLS REQUIRED

Phillips

screwdriver

Safety

goggles

10 .mm

Wrench

13 .mm

Wrench

Summary of content (5 pages)

PAGE 1
ASSEMBLY TOOLS REQUIRED Phillips screwdriver Safety goggles 10 mm. Wrench 13 mm. Wrench INSTALL THE SIDE HANDLES Install the side handles (C) on the bottom cabinet and the top chest to make it easier to lift and move the product. Position the side handles (C) over the holes and attach with the 24 M6 X 1.0 (B) Hex bolts provided. Tighten securely. B C INSTALL THE CASTERS Carefully lay bottom cabinet on its back.
PAGE 2
ASSEMBLY Assembly Instructions (continued) INSTALL THE MOUNTING BRACKETS Place top chest on top of the bottom cabinet first, then install the mounting brackets to secure the top chest to the bottom cabinet. Position the mounting brackets (D) over the holes and attach with the 8 M4 X 12L Screws (E) provided. Tighten securely. E INSTALL THE DRAWER LINERS Place the drawer liners (L) in the drawers to protect the drawer surfaces. Place the liners (L) inside the top compartment and inside of each drawer.
PAGE 3
OPERATION Usage Instruction TO REMOVE THE DRAWERS Pull drawer out so it is fully extended. Press the right hand side blue lever down , and the left hand side blue lever up. While holding the levers in the positions as instructed above, pull the drawer outward until it is released from the drawer slide (F). PRESS DOWN RIGHT HAND SIDE F TO REPLACE THE DRAWERS Extend the drawer slides (F) from the tool chest, being careful that the slides are positioned into the slot.
PAGE 4
OPERATION TO REMOVE THE DRAWER SLIDE For Outer Slide: 1. Extend the drawer slide to full length. 2. Insert the tip of a pry-bar just behind the first tab between the cabinet wall and the slide. Gently pry the slide outward.(See Pic 1). 3. Push up on the drawer slide to free the first tab. Pull the slide forward slightly and free the rear tab. For Inner Slide : 1. Remove the drawer in which the inner slide is attached. 2.
PAGE 5
MAINTENANCE INFORMATION MAINTAINING THE DRAWERS 1. Periodically clean the drawer trim, and inside the drawers with a mild detergent and water. 2. Remove grease and oil with a standard, nonflammable cleaning fluid. 3 . The use of drawer liners is recommended to protect the finish inside the drawers and make. the drawers easier to clean. 4. Lubricate the slides semi-annually with grease or equivalent. MAINTAINING THE CASTERS 1. Grease the casters annually using high quality bearing grease.