User's Manual

TRANSMITTER PROGRAMMING

Note: All transmitter codes must be learned at time of programming!! The RS-1G3 learns up to 4 different

transmitter codes.

1. Turn Ignition Key to the ON position.

2. Press Programming button 4 times, then after a few seconds the unit flashes the parking lights 4 times.

3. Press the start button of the first transmitter. You should get 1 light flash confirming the remote is coded, then

press the start button of a second transmitter, the unit will flash 2 times confirming the remote is coded and so

on. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key off. See

diagram below.

IGN

OFF

WAIT FOR

4 FLASHES

PRESS 4X's

FLASH 2, 3, or 4 X's

IGN

OFF

PRESS START BUTTON