LIMITED LIFETIME WARRANTY ORIGINAL CEILING FAN LIMITED LIFETIME WARRANTY The limited lifetime warranty covers this ceiling fan, for residential use by the original purchaser, against defects in material or workmanship as follows: If your Ceiling Fan motor fails at any time during the lifetime of the original purchaser due to defects in material or workmanship, we will provide a replacement part free of charge.
Package Contents: AAR Gud X16 55 => £2 oxo Unpack your fan and check the contents. You should have the following items. 1.) Hanger Bracket 2.) Canopy 3.) Down rod Set (Includes Hanger Ball, 10” Down rod, Hanger Pin & Lock Pin) 4.) Down rod Stand Cover 5.) Blade Bracket (5 PCS) 6.) Housing 7.) Fan Blade (5 PCS) 8.) Fan Light Bracket 9.) Fan Light 10.) Glass Shade 11.) Decorative Cap 12.) Remote Control Set (Includes Transmitter & Receiver) 13.) Assembly Kit 14.) Installation Instructions 15.
Exploded View Detail [J Hanger Bracket Hanger Ball Canopy Decorative Cap Down rod Down rod Stand Cover Lock Pin liar Housing = mg Blade Bracket Light Kit Bracket Blade—— Dual Mount Drawing Down rod Mount Slope Ceiling Mount (Up to 23 degrees) PAGE: 3/9
Safety Instructions READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLING THE FAN AND SAVE INSTRUCTIONS. ® All set screws of the fan must be checked and re tightened where necessary before installation. © To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning fan. Do not insert foreign objects in between rotating fan blades.
INSTALLATION INSTRUCTIONS IMPORTANT: © BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN. ® SAVE ALL INSTRUCTIONS. NOTE: The fan weight is 20.28Ibs {9.2kgs}. Be sure the outlet box you are using is securely attached to the building structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Antenna; DO NOT CUT OR SPLICE Hanger Bracket Hanger Ball Move the Ground Wires (a), Quiet Box wires (b), and Motor Wires (c}) away from the center of the Hanger Bracket. Then slide Receiver through Hanger Bracket as shown, Antenna end first, unl! It Is centered. Finally, cut Motor Wires (c) to length needed for connections. Make wire connections: 1) The Motor white wire to the white "TO MOTOR N” wits from Receiver with a wire connector.
Fan Light Installation Make wire connection: -connect the blue wire from the miter to blue wire from the light plate with wire connector. -connect the white wire from the motor to white wire from the light plate with w Ire connector. Carefully put the wires into the fan light bracket Attach the light plate to the fan light bracket by using three screws and washers. Carefully insert glass shade up into fan light and secure in place by rotating glass shade. DO NOT over tighten.
Trouble Shooting Guide If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Guide. If a problem cannot be remedied or you are experiencing difficulty in installation, please call our Customer Service Department. PROBLEM SUGGESTED REMEDY . Check main and branch circuit fuses or circuit breakers. 2.
DYNAMIC BLADE BALANCING KIT YARDSTICK -. 0—— BALANCING WEIGHT £ CENTER LINE MEASURING POINT . “+ COUNTERCLOCKWISE PLASTIC CLIP PREFACE Your ceiling fan may sometimes have wobbling problems when operating due to irregularity in the blades or the blade brackets. Improper assembly in the mounting system may cause some additional problems. This balancing kit can be used to fix wobbling problems. DYNAMIC BLADE BALANCING KIT FOR CEILING FANS 1. Make sure that all blades are firmly screwed into the blade brackets.