Instructions / Assembly

renincorp.com • acmesystemsandhardware.com
BARN DOOR HARDWARE KIT
BD102K-07800
ASSEMBLY INSTRUCTIONS
Step 1. Door Preparation
Note, a second optional wall-mounted door guide has
also been provided in this kit should you not wish to
mortise your door.
Mortise 1/4" wide x 3/4" deep groove centrally to the bottom
of the door for use with the oor-mounted door guide. This
will ensure smoothness of door travel side-to-side and will
prevent the door from swinging in and out.
If you prefer, you can also have your door mortised at
the store you have purchased your door (typically, for an
additional charge). See your store for details.
3/4" (19mm)
1/4"
(6.3mm)
Step 3. Door Preparation - Anti-jump block Installation
Position each anti-jump block at least 1" from the edge of the
Straps. Tighten slightly to secure in place.
5.12"
(130 mm)
1.58"
(40 mm)
Step 2. Door Preparation – Strap Installation
Position each strap to the front of the door centre to the stile
or a minimum of 2" from the edge of the door.
Measure 1 9/16" (40mm) from the top of the door to correctly
position the rst hole for the height of the straps.
Mark holes with a pencil and pre-drill 3/8" holes, then secure
into place. Repeat for second strap.