Instruction Manual
2.2.3 Product Dimensions
2.3 Proper Cooling Considerations
Because CVA Series ampliers regulates their temperature using con-
vection cooling and no fans, the ampliers must be given adequate
space to allow for proper airow. Do not stack the ampliers on top of
each other or mount it in a way that other equipment will block airow
along the surfaces of the case.
CAUTION: Inadequate airow to the amplier can cause the
amplier to overheat and potentially become damaged in
the process. Be sure to provide plenty of air space to allow
for convection cooling.
2.4 Input Connections (NET+ Models Only)
Your CVA Series amplier is provided with a 3-pin Euro Block connector
for its input connection. This connector will accept both balanced or
unbalanced connections, however some modications must be made
for an unbalanced connection. See the next two sections for instruc-
tions on connecting your amplier to its input source.
2.4.1 Balanced Input Connections
When using a balanced input source and connector, you must ensure
that the hot, cold, and ground pins of the connector are matched up to
the +, -, and ground pins of the CVA Series’ Euro Block connector re-
spectively. Diagrams have been provided for standard XLR and TRS
connectors. Please refer to the manual of your input source in case it
does not follow the standard pin-out.
NOTE: The CVA Series of ampliers do not accept TRS in-
puts wired for a stereo source. TRS inputs should only be
used for balanced mono inputs.
CVA50-1 NET+
6.00in
15.3cm
1.25in
3.2cm
1.25in
3.2cm
4.00in
10.2cm
Front
Side