MSDS

ManualsBrandsSticky Jack ManualsPaintMulti-Pack - 1 8 oz. Bottle of SJG, 1 35 yd Roll of SJT, 1 10 g Bottle of SJSG

MATERIAL SAFETY DATA SHEET

Product Name: Sticky Jack Glue HMIS Codes: H F R P

Polyurethane Adhesive 2 1 1 K

SECTION I – MANUFACTURER IDENTIFICATION

MANUFACTURER’S NAME: SAG INTERNATIONAL, LLC

ADDRESS: PO Box 50522

PASADENA, CA 91115

EMERGENCY PHONE: (800) 424-9300 INFORMATION PHONE: 626-577-9130

DATE REVISED: June 19, 2008 NAME OF PREPARER: RON ROTH

REASON REVISED: NEW FORMULATION

S ECTION II – HAZARDOUS INGRED IENTS /S ARA III INFORMATION

Occupational Exposure Limits Vapor Pressure Weight

Hazardous Components CAS Number OSHA PEL ACGIH TLV Other mm Hg @ T emp Percent

Urethane Prepolymer** Trade Sec. 0.02 ppm 0.005 ppm TWA n/a 60

*Polymeric MDI (Contains 4,4’ MDI, CAS # 101-68-8) 9016-87-9 0.02 ppm .005 ppm TWA n/a 40

*Indicates toxic chemical(s) subject to the reporting requirements of section 313 of Title III and of 40 CFR 372.

**Exposure limits represent those established for the 4,4’ MDI component of the polymeric MDI

The level of 4,4’ MDI (CAS#101-68-8) present in the polymeric MDI is < 80%.

The vapor pressure of this product is less than 1 x 10¯

mm Hg at 77°F

**Exposure limits represent those established for the 4,4’ MDI (CAS # 101-68-8) component of the prepolymer.

S ECTION III – PHYS ICAL/CHEMIC AL CHARACTERIS TICS

Boiling Point: Decomp. @ 646 F Specific gravity (H2O=1): 1.1

Vapor Density: Heavier than air Evaporation Rate: Slower than ether

Coating V.O.C.: N/A

Material V.O.C.: N/A

Solubility in Water: Nil, reacts with water

Appearance and Odor: Translucent amber syr

Summary of content (12 pages)

PAGE 1
MATERIAL S AFETY D ATA S HEET Product Name: Sticky Jack Glue Polyurethane Adhesive HM IS Codes: H F R P 2 1 1 K S ECTION I – MANUFACTURER ID ENTIFIC ATION MANUFACTURER’S NAME: SAG INTERNATIONAL, LLC ADDRESS: PO Box 50522 PASADENA, CA 91115 EMERGENCY PHONE: (800) 424-9300 DATE REVISED: June 19, 2008 REASON REVISED: NEW FORMULATION INFORMATION PHONE: 626-577-9130 NAME OF PREPARER: RON ROTH S ECTION II – HAZARDOUS INGRED IENTS /S ARA III INFORMATION Hazardous Components Urethane Prepolymer** *Polymeric MD
PAGE 2
Sticky Jack Glue MATERIAL SAFETY DATA SHEET PAGE 2 OF 4 S ECTION IV – FIRE AND EXPLOS ION HAZARD DATA Flash Point: 390F Method Used: COC Flammable Limits in Air by Volume - Lower: N/A Upper: N/A Extinguishing Media: Foam, CO2, Dry chemical SPECIAL FIREFIGHTING PROCEDURES Firefighters must wear positive pressure self-contained breathing apparatus and full protective clothing to protect against isocyanate vapors.
PAGE 3
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE SKIN: Skin sensitization and irritation may develop after repeated and/or prolonged contact with human skin. EYES: Contact will irritate human eyes. SAG MATERIAL SAFETY DATA SHEET PAGE 3 OF 4 SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE This material will not normally be absorbed through human skin. INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE LD50 for rats is probably above 5000mg/kg.
PAGE 4
OTHER PRECAUTIONS Based on available data repeated exposures do not cause additional significant adverse effects. Sticky Jack Glue MATERIAL SAFETY DATA SHEET PAGE 4 OF 4 S ECTION VIII – CONTROL MEAS URES RESPIRATORY PROTECTION Atmospheric levels should be maintained below the exposure guideline. Use an approved supplied air respirator or an approved positive pressure self-contained breathing apparatus if these levels are exceeded. VENTILATION Provide general and/or local exhaust.
PAGE 5
SAG International, LLC 900 S. Primrose Ave. Monrovia, CA 91016 Tel: (877) 845-8530 Fax: (626) 698-0668 www.StickyJackGlue.
PAGE 6
-Accidental Release Measures Steps to be taken in case of spill or leak: Flood with water to polymerize. Soak up with inert absorbent. 7- Handling and Storage: Safe storage: Handling: Store away from heat and direct sunlight to maximize shelf life. Store inside in a dry location. Keep container tightly closed. Avoid contact with skin. Avoid breathing vapors.
PAGE 7
12-Ecological Information No Data 13- Disposal Considerations: Spill or accidental release: Disposal procedures: Flood with water to cure (harden) adhesive. Soak up with an inert absorbent. Incinerate or dispose of in an approved landfill in accordance with local and EPA regulations. Not a RCRA hazardous waste.
PAGE 8
First Aid Supplement Cyanoacrylate adhesive is a very fast setting and strong adhesive. It bonds human tissue and skin in seconds. Experience has shown that accidents due to Cyanoacrylates are best handled by passive, non-surgical first aid. Treatment of specific types of accidents are suggested as follows: Skin Contact- Remove excess adhesive. Soak in warm, soapy water. The adhesive will come loose from the skin in several hours. Dried adhesive does not present a health hazard even when bonded to the skin.
PAGE 9
MATERIAL SAFETY DATA SHEET _________________________________________________________________________________________________ 1.
PAGE 10
SAG International Sticky Jack Tape Material Safety Data Sheet _________________________________________________________________________________________________ 6. ACCIDENTAL RELEASE MEASURES No specific measures necessary. Prevent the material from entering drains or watercourses. _________________________________________________________________________________________________ 7. HANDLING AND S TORAGE Keep away from heat and sources of ignition.
PAGE 11
SAG International Sticky Jack Tape Material Safety Data Sheet _________________________________________________________________________________________________ 10. STABILI TY AND REACTIVI TY Stability Stable under normal conditions. Conditions to Av oid - Heat - High temperatures Materials to Av oid Acids — bases — strong oxidizers Hazardous Polymerization Will not occur.
PAGE 12
SAG International Sticky Jack Tape Material Safety Data Sheet _________________________________________________________________________________________________ 15. REGULATORY INFORMATION EU Label Information Classification and labelling have been performed according to EU directives 67/548/EEC and 99/45/EC including amendments(2001/60/EC and 2006/8/EC) EC Annex I Classification According to EC Commission Directive 67/548/EEC this product is not classified. R phrases None. S phrases None.