Install Instructions

OPERATION
Settings
www.stiebel-eltron-usa.com CK Plus & CK Premium | 7
ENGLISH
6.2 Standby mode
Material losses
In standby mode, the heater will not produce heat under
any circumstances. Frost protection is deactivated until
the heater is taken out of standby mode.
f To switch on the programming unit, press “Standby”. The
standard display appears.
f To put the programming unit and the heating heater into
standby mode, press “Standby”. The display shows “- - - -”.
7. Settings
7.1 Operating lock
f To lock or unlock the user interface, press and hold
“+” and “–” simultaneously for 5seconds.
7.2 Standard display
D0000075500
The standard display is continuously shown. If no user input is
detected for longer than 20seconds while in the menu, the device
automatically switches to the standard display.
The standard display shows the current room set temperature, as
well as the “Editable parameter” symbol. You can use “+” and “–”
to change the room set temperature.
If the room set temperature corresponds to one of the values
established for the comfort or night mode temperature settings,
the symbol for the corresponding operating mode (comfort mode,
night mode) appears in the menu bar.
The room set temperature can also be changed manually with a
time program active. The changed set room temperature is main-
tained until the next programmed switching point is reached.
7.3 Standard menu
To access the standard menu, briefly press “Menu”. You can now
call up the following menu items:
Display Description
Select the day of the week and the time
Select comfort temperature setting
The comfort temperature must be set at least 1 °F (0.5 °C)
higher than the night mode temperature.
Select night mode temperature setting. The night mode
temperature must be set at least 1 °F (0.5 °C) lower than the
comfort temperature.
Display Description
Switch “Window open detection” function on and off
Select time program (Pro1, Pro2, Pro3, Pro4) or deactivate
(off)
Switch “Adaptive start” function on and off
Set silent mode
CK 150-1 Premium:
Lo = quiet 750 W base heating stage
Hi = powerful 1500W rapid heating stage
CK 150-2 Premium:
Lo = quiet 1000 W base heating stage
Hi = powerful 2000 W rapid heating stage
To change the setting of a menu item, call the relevant menu item
up using “+” and “–”. Press “OK”.
As soon as the “Editable parameter” symbol appears, you can
change the setting of the menu item with “+” and “–”. Press “OK”
to save the setting.
To exit the standard menu, press “Menu”. The standard display
appears.
7.3.1 120-minute short-time timer (Pro 4)
With the 120-minute short-time timer, you can activate comfort
mode for a selected time of up to 120minutes. During this selected
time, the unit heats to the set comfort temperature value. After
this, the heater operates in night mode.
f If you wish to use the 120-minute short-time timer, select
time programPro4 from the standard menu.
D0000075531
The standard display shows the selected time in minutes as well as
the “Editable parameter” symbol. Using the “+” and “-” buttons,
you can select any length of time from 10–120minutes.
To activate the short-time timer, press “OK”. The heater switches
to comfort mode until the end of the selected time. The minute
display flashes during this period.
If you wish to stop the short-time timer, press and hold “OK” for
longer than 3seconds.
At the end of the selected time, the heater automatically reverts
to night mode.
7.3.2 Silent mode
You can choose between the following two heating outputs with
matched fan speed: