Owner's Manual
You can run chains of different pitches
on this chainsaw - depending on the
chain sprocket (see “Specifications”)
The chain pitch must match the guide
bar. In addition, the drive link gauge
must match the guide bar groove width.
•
••
•
Pull out the hinged handle (1) of the
wingnut so that it snaps into posi-
tion.
•
••
•
Turn the wingnut (2) counterclock-
wise until it hangs loose in the chain
sprocket cover (3).
•
••
•
Remove the sprocket cover.
•
••
•
Remove the tensioning gear (4)
and turn it over.
•
••
•
Take out the screw (5).
•
••
•
Position the tensioning gear (6)
against the guide bar (7).
•
••
•
Fit and tighten down the screw (8).
2
3
1
135BA003 KN
Mounting the Bar and Chain
Models with Quick Chain Tensioner
4
135BA004 KN
5
135BA005 KN
6
7
135BA006 KN
8
135BA007 KN
26 017, 018