Owner's Manual
Clean the air filter when there is a
noticeable loss of engine power.
•
••
•
Press down the interlock lever and
set Master Control lever to
“Cold Start” l
•
••
•
Turn the twist lock above the rear
handle 90° counterclockwise
•
••
•
Lift off the shroud vertically.
•
••
•
Lift filter off vertically.
•
••
•
Wash filter element in a clean,
non-flammable cleaning solution
(e.g. warm soapy water) and then
dry.
Always replace a damaged filter
element.
•
••
•
Reinstall the filter.
•
••
•
Turn the bar over -
every time you sharpen the chain -
and every time you replace
the chain - this avoids one-sided
wear, especiallly at nose and under-
side of the bar.
Regulary clean
1 = oil inlet hole
2 = oilway
3 = bar groove.
•
••
•
Measure groove depth -
with scale on filing gauge*-
or in area used most for cutting on
Rollomatic bars -
Chain Chain Minimum
type pitch groove depth
Picco-Mini 3/8" 5.0 mm (0.20")
If groove depth is less than specified:
•
••
•
Replace the guide bar.
The drive link tangs will otherwise scrape
along the bottom of the groove - the
cutters and tie straps will not ride on the
rails.
* Special accessory
Cleaning Air Filter
143BA054 ST
143BA022 KN
Dirty air filters reduce engine power,
increase fuel consumption and make
starting more difficult.
Taking Care of Guide Bar
3
2
143BA055 KN
1
38 017, 018