Owner's Manual

7KHIRXUSRVLWLRQV
RIWKH0DVWHU&RQWUROOHYHU
To start the engine, move the lever to
"Cold Start" position -
do not use force.
If the Master Control lever is on
"Run": Press down the throttle trigger
interlock - and move the Master Control
lever downward.
"Cold Start" position: Choke shutter is
closed - throttle trigger is in starting-
throttle position. A cold engine should
be started in this position.
As soon as engine begins to fire,
move the Master Control lever to
"Warm Start" position :
Move the Master Control lever one
notch upward.
"Warm Start" position:
Choke shutter is open -
throttle trigger is in starting-throttle
position
If you leave the Master Control lever
in the "Cold Start" position,
the combustion chamber will flood
and stall the engine.
The Master Control lever must be in
"Warm Start" position to start a warm
engine. Also select this position if engine
has been running but is still cold.
The Master Control lever should not be
forced to "Run" position -
it will move to "Run" as soon as the
throttle trigger is activated.
In the "Warm Start" position, continue
cranking after engine begins to fire.
As soon as the engine runs,
LPPHGLDWHO\ blip the throttle trigger
so that the Master Control lever moves to
"Run" -
idling position -
normal operating position .
7RVKXWGRZQWKHHQJLQH
Move the Master Control lever upward
to "STOP" position :
The stop contact engages the contact
spring - this cuts out the ignition system.
,QIRUPDWLRQ%HIRUH<RX6WDUW
GRQ¶WVWDUWWKHHQJLQH\HW
143BA013
1
2
3
STOP
0
143BA014
2
0
STOP
143BA015
3
4
STOP
0
 