Owner's Manual

•
Pull off the spark plug terminal -
•
Take out screw and remove the
shroud -
•
Unscrew and dry off the spark plug -
•
Set the Master Control lever to G
•
Crank the engine several times
with the starter
to clear the combustion chamber -
•
Refit the spark plug and connect
the spark plug terminal -
reassemble all other parts
•
Set Master Control lever
to "Warm Start" Q
even if engine is cold -
•
Now start the engine.
)XHOWDQNUXQXQWLOGU\
DQGWKHQUHIXHOHG
•
Pull starter rope several times until
fuel line is primed.
The saw chain must always throw off
a small amount of oil.
•
Never operate your saw without
chain lubrication. If the chain is run
dry the whole cutting attachment
will be irretrievably damaged within
a very short time.
Always check chain lubrication and
oil level in tank before starting work.
•
Every new chain has to be broken
in for about 2 to 3 minutes.
•
After breaking in chain,
check chain tension
and adjust if necessary -
see section
"Checking chain tension".
Different quantities of oil are required for
different bar lengths, types of wood and
cutting techniques.
Use the adjusting screw () to vary the
oil feed rate as required.
•
Most economic setting -
turn adjusting screw to "("
((matic position).
•
To increase oil feed -
turn adjusting screw clockwise.
•
To reduce oil feed -
turn adjusting screw counter-
clockwise.
Your chain must always be wetted with
a film of lubricant.
143BA024 KN
&KHFNLQJ&KDLQ/XEULFDWLRQ
1
145BA011 K
2LO4XDQWLW\
&RQWURO
 