Owner's Manual

'HSWKJDXJHVHWWLQJ
The depth gauge determines the height
at which the cutter enters the wood and
thus the thickness of the chip removed.
Distance between depth gauge and
cutting edge = D
Chain Depth gauge
pitch distance “D”
Inch (mm) mm (Inch)
1/4 (6.35) 0.65 (0.026)
3/8-PM (9.32) 0.65 (0.018)
3/8-PMN (9.32) 0.45 (0.026)
0.325 (8.25) 0.65 (0.026)
3/8 (9.32) 0.65 (0.026)
0.404 (10.26) 0.80 (0.031)
This setting may be increased by 0.2 mm
(0.008") for cutting softwood in mild
weather season - no frost.
/RZHULQJGHSWKJDXJHV
The depth gauge setting is reduced
when the chain is sharpened. Use filing
gauge to check the setting every time
you sharpen the chain and, if necessary,
lower the depth gauge with a flat or
triangular file so that it is level with the
filing gauge.
Round off depth gauges parallel to the
stamped marking.
$IWHUVKDUSHQLQJ
Clean the chain thoroughly, remove
filings or grinding dust - lubricate the
chain by immersing it in an oil bath.
%HIRUHORQJRXWRIVHUYLFHSHULRG
Clean the chain with a brush and
immerse it in an oil bath.
689BA024 KN
a
689BA023 KN
6KDUSHQLQJWRROV
Chain pitch Round file Ø Round file File holder Filing gauge Flat file Sharpening kit*
Inch (mm) mm (Inch) Part No. Part No. Part No. Part No. Part No.
1/4 (6.35) 4.0 (5/32) 5605 772 4006 5605 750 4327 1110 893 4000 0814 353 3356 5605 007 1027
3/8 PMN (9.32) 4.0 (5/32) 5605 772 4006 5605 750 4327 0000 893 4000 0814 353 3356 5605 007 1026
3/8 P (9.32) 4.0 (5/32) 5605 772 4006 5605 750 4327 1110 893 4000 0814 353 3356 5605 007 1027
0.325 (8.25) 4.8 (3/16) 5605 772 4806 5605 750 4328 1110 893 4000 0814 353 3356 5605 007 1028
3/8 (9.32) 5.2 (13/64) 5605 772 5206 5605 750 4329 1110 893 4000 0814 353 3356 5605 007 1029
0.404 (10.26) 5.5 (7/32) 5605 772 5506 5605 750 4330 1106 893 4000 0814 353 3356 5605 007 1030
* consisting of file holder with round file, flat file and filing gauge.
