Instruction Manual

Table Of Contents
11.4 Blow-Sweeping
0000-GXX-4440-A0
Point the nozzle at the ground.
Walk slowly and steadily forwards.
12 After Finishing Work
12.1 After Finishing Work
Switch off the blower, move retaining latch to
position and pull the connecting cable plug
out of the socket.
If the blower is wet: Allow the blower to dry.
Clean the blower.
13 Transporting
13.1 Transporting the blower
Switch off the blower, move retaining latch to
position and pull the connecting cable plug
out of the socket.
Carrying the blower
Carry blower by the control handle in one
hand.
Transporting the blower in a vehicle
Secure the blower so that it cannot topple over
and cannot move.
14 Storing
14.1 Storing the Blower
Switch off the blower, move retaining latch to
position
and pull the connecting cable plug
out of the socket.
Observe the following points when storing the
blower:
Blower is out of the reach of children.
Blower is clean and dry.
15 Cleaning
15.1 Cleaning the blower
Switch off the blower, move retaining latch to
position
and pull the connecting cable plug
out of the socket.
Clean blower with a damp cloth.
Clean vents with a paintbrush.
Clean the shield with a paintbrush or soft
brush.
16 Maintenance and Repairs
16.1 Maintenance Intervals
The maintenance intervals are dependent on the
environmental and operating conditions. STIHL
recommends the following maintenance inter‐
vals:
Every 12 months
Have the blower checked by a STIHL servic‐
ing dealer.
16.2 Servicing and Repairing the
Blower
The blower cannot be serviced or repaired by the
user.
If your blower has a malfunction or is dam‐
aged or requires servicing: Contact your
STIHL servicing dealer.
17 Troubleshooting
17.1 Troubleshooting the Blower and Battery
Condition LEDs on Bat‐
tery
Cause Remedy
Blower does not
start when swit‐
ched on
1 LED flashes
green.
Battery has low
charge.
Recharge the battery fully as described
in the instruction manual for the STIHL
AL 101, 300, 500 chargers.
12 After Finishing Work English
0458-711-9821-C 25