Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 IMPORTANT SAFETY INSTRUCTIONS
- 6 Charger Safety
- 7 Maintenance, Repair and Storage
- 8 General Warnings and Instructions
- 9 Before Starting Work
- 10 Charging the Blower
- 11 LED Diagnostics
- 12 Assembling the Blower
- 13 Inserting and Removing the Activation Key
- 14 Switching the Blower On and Off
- 15 Checking the Controls
- 16 During Operation
- 17 After Finishing Work
- 18 Transporting the Blower
- 19 Storing the Blower and Charger
- 20 Cleaning
- 21 Inspection and Maintenance
- 22 Troubleshooting Guide
- 23 Specifications
- 24 Replacement Parts and Equipment
- 25 Disposal
- 26 Limited Warranty
- 27 Trademarks
- 28 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 6 Seguridad del cargador
- 7 Mantenimiento, reparación y almacenamiento
- 8 Advertencias e instrucciones generales
- 9 Antes de empezar a trabajar
- 10 Carga del soplador
- 11 Diagnóstico de LED
- 12 Armado del soplador
- 13 Inserción y retiro de la llave de activación
- 14 Encendido y apagado del soplador
- 15 Revisión de los controles
- 16 Durante el funcionamiento
- 17 Después de completar el trabajo
- 18 Transporte del soplador
- 19 Almacenamiento del soplador y el cargador
- 20 Limpieza
- 21 Inspección y mantenimiento
- 22 Guía de solución de problemas
- 23 Especificaciones
- 24 Piezas y equipos de repuesto
- 25 Eliminación
- 26 Garantía limitada
- 27 Marcas comerciales
- 28 Direcciones
0458-719-8621-A
22
English
20 Cleaning
To properly store the charger:
► Disconnect the charger from the wall outlet.
► Disconnect the charger from the blower.
► Store the charger indoors in a dry and secure location.
► Keep it out of the reach of children and other unauthorized
persons.
20.1 Cleaning the Blower and Charger
WARNING
To reduce the risk of personal injury from unintended
activation, remove the activation key before carrying out any
cleaning work, @ 7.1. Users of this blower should carry out
only the cleaning described in this manual.
To clean the blower and charger:
► Clean a dirty intake screen carefully with a soft brush
whenever required.
► Clean the blower's plastic components with a slightly
dampened cloth. Do not use detergents or solvents. They
may damage the polymer components.
► Do not use a pressure washer to clean the blower or spray
it with water or other liquids.
► Keep the charger housing and electrical contacts free
from foreign matter. Clean as necessary with a soft brush
or soft, dry cloth. Always unplug the charger before
cleaning.
21.1 Inspecting and Maintaining the Blower
WARNING
To reduce the risk of personal injury from unintended
activation, remove the activation key before inspecting the
blower or carrying out any maintenance, @ 7.1. Carry out
only the maintenance operations described in this manual.
There are no user-authorized repairs. STIHL recommends
that repair work be performed by authorized STIHL servicing
dealers.
To properly maintain the blower:
► Inspect the intake screen of the blower and replace if
damaged.
► Have worn, missing or damaged safety labels replaced by
an authorized STIHL servicing dealer.
If you make a warranty claim for a component that has not
been serviced or maintained properly, coverage may be
denied.
20 Cleaning
21 Inspection and Maintenance